andy pugh
2017-07-24 22:53:42 UTC
On 22 July 2017 at 22:27, Greg Bentzinger via Emc-users
just use ordinary LinuxCNC?
I was using a lathe this weekend that was running Gmoccapy with
NativeCAM and it was very usable, if not quite so fancy-looking as PP.
Most of my work is done using Touchy with my own set of simple macros:
https://forum.linuxcnc.org/41-guis/26550-lathe-macros?start=150#82743
I ask this as I am considering a conversion on a benchtop lathe I keep for simple second op work
Do you really need the conversational stuff that PP has, or could youjust use ordinary LinuxCNC?
I was using a lathe this weekend that was running Gmoccapy with
NativeCAM and it was very usable, if not quite so fancy-looking as PP.
Most of my work is done using Touchy with my own set of simple macros:
https://forum.linuxcnc.org/41-guis/26550-lathe-macros?start=150#82743
--
atp
"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1916
atp
"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1916