[Emc-users] latest emulator vs tool change is no go

[Gene Heskett]

Greetings all;

Trying to get a handle on the tool.tbl, I noted that tool 6, which I
think I added a couple years back to help me see some gcode I was
writing at the time, better.

But I just fired up the latest sym and cannot execute the m6t6 command,
LCNC say it cannot do it until homed.

Just one problem, it IS homed with the register icons enabled left of Rad
and Z in the backplot.

??? Won't "run" anything in fact.

2.8.0-pre-3187

Anything I can check/do?

Cheers, Gene Heskett

[Gene Heskett]

Post by Gene Heskett
Greetings all;
Trying to get a handle on the tool.tbl, I noted that tool 6, which I
think I added a couple years back to help me see some gcode I was
writing at the time, better.
But I just fired up the latest sym and cannot execute the m6t6
command, LCNC say it cannot do it until homed.
Just one problem, it IS homed with the register icons enabled left of
Rad and Z in the backplot.
??? Won't "run" anything in fact.
2.8.0-pre-3187
Anything I can check/do?

Apparently this is a sim only problem, I just checked a real machine, and
it works as expected. So far, only one canary has died. ;-)

Thanks everybody.

Cheers, Gene Heskett